The EZhotspot Extender has a single LED display compromising of a BLUE and GREEN indicator for important processes and current status
The LED is an important aspect to indicate the intensity of the wireless connectivity. When disabled, it will be automatically enabled upon joining to another remote wireless network.
While it maybe slightly unpleasant in view, the best suggestion currently would be to apply a small piece of black electrical insulating tape over the LED. When needed, it can be easily unpeeled to reveal the signal.
The LED disabling in the EZwizard menu will be considered for Future firmware release
With Firmware version 5.71, you can disable/enable the LED from the EZwizard menu.
However, version 5.71 can only be manually flashed at the moment.
A Newer Version 5.73 is however also scheduled to be released in May/June from the OTA Firmware Upgrade menu.
During a Hard Factory Reset, any blinking LED in any fashion is normal and the initiation may take up to 9 minutes to complete, after which the LED will be blinking in less active manner. The blinking interval contrast will be easily recognized in person.
A Solid Green LED upon start up that lasts more than 30 seconds and followed by no blinking activity may indicate a corrupted file system. It can be recovered with our recovery package. Kindly see below link.
When the EZhotspot Extender is normally powered or reset button pressed
- A Solid GREEN/TURQUOISE led (~12 seconds) indicating a pre-boot internal system checks & diagnosis
|V5||A blinking GREEN led (~30 seconds) indicating loading of kernel/Operating System and necessary drivers|
|V4||A blinking BLUE led (~30 seconds) indicating loading of kernel/Operating System and necessary drivers|
When the EZhotspot Extender is connected to a remote wireless network or hotspot, the blinking rate of the GREEN led on a BLUE background shows the current wireless connectivity status
- Excellent connectivity
- Fair ~ Good connectivity
- Intermittment ~ Fair connectivity
- Bad ~Intermittement connectivity
Note: Due to close proximity of the different LED colors, the GREEN led may appear TURQUOISE in different environment
During flashing or upgrading of firmware
|V5||A constant blinking BLUE led is indicated|
|V4||A constant blinking GREEN led is indicated|
Note: Never remove power at this point!